LEMON Manuals: Even more car manuals for everyone
Home >> Renault >> 1987 >> Alliance/Encore L4-1721cc 105 CID >> Repair and Diagnosis >> Powertrain Management >> Emission Control Systems >> Technical Service Bulletins >> Recalls >> Recall - Catalytic Converter Defect >> Service Procedure

Service Procedure

FIGURE 1:




1. Saturate the nuts at the front of the converter and exhaust pipe clamp at the rear of the converter with Mopar Rust Penetrant PN 4318039 or equivalent (Figure 1). Allow 5 minutes for penetration.
2. Remove the nuts, studs, springs and exhaust pipe clamp and discard.

3. Heat the rear exhaust pipe-to-converter joint with an oxyacetylene torch until metal becomes cherry red.

4. While the joint is hot, twist the converter back and forth until it becomes disengaged from the rear exhaust pipe.

5. Remove the exhaust seal from the exhaust manifold.

6. Connect the new converter to the rear exhaust pipe.

7. Attach the front pipe to the exhaust manifold using new provided exhaust seal, springs, studs, and nuts. Do not tighten the nuts.

8. Align the pipe and tighten the new exhaust pipe clamp at the rear exhaust pipe.

9. Tighten the manifold-to-catalytic converter attaching nuts to 27 N-m (20 ft.lbs).

Caution: The spring coils must never be compressed to touch. If they are touching, loosen the nuts until the coils separate slightly.